One component joint filling material
LinoFlex 40 is a single component polyurethane based elastomeric sealant which cures under the effect of atmospheric humidity to form a flexible and resistant joint with very good adhesion on most materials.
Technical description:
Appearance | Pasty |
Colour | Grey |
Density at 20 °C | 1.16 ± 0.05 |
Conventional solids content (EN 827) | > 93 % |
Sagging (ISO 7390) | None |
Application temperature | + 5 to 35°C |
Skin formation time at 23 °C and 50 % HR | 90 to 135 min |
Curing time at 23 °C and 50 % HR | 3 mm/24 h |
Final Shore A hardness (ISO 868 – 3 seconds) | Ca 40 |
Modulus at 100 % (ISO 8339) | Ca 58 psi (0.4 MPa) |
Elongation at break (ISO 8339) | > 600 % |
Temperature resistance | -30 to +80 °C |
Resistance to diluted acids and bases | Average |
UV resistance | Good |
Water and salt spray resistance | Excellent |
Compatibility with water based paints | Yes |
Compatibility with solvent based paints | Test must be carried out |
Safety:
Not classified as hazardous.
Consumption:
600 ml will be enough for approx 15 m joint, based on width of 4 mm and 10 mm depth.
Cleaning:
Tools should be cleaned with acetone before the sealant has completely cured. After curing, abrasion is necessary.
Packaging and storage:
600 ml sausages, 20 pcs per box and 720 pcs per pallet. 12 months in the original, hermetically sealed cartridges in.
Laying instruction:
- The surface must be clean, dry, free of dust, oil, grease and any contaminants that could harm bonding. If the substrates need to be cleaned use acetone.
- Apply Lino primer for better bounding.
- LinoFlex 40 can be applied with a manual or pneumatic gun.
- After application, use a putty knife with soapy water to smooth the joint.
- Linoflex 40 should be used within 24 hours of opening the cartridge protection. (otherwise, the sealant could harden in the cartridge)
- Do not apply at a temperature under + 5 °C. In cold weather, store the Linoflex at 20 °C before use.
- Avoid any contact with non-cured Linoflex.
AB Lindec endeavours to provide correct information about technical properties and handling of its products. However, while AB Lindec has no control over the way in which the products are mixed and laid, or the conditions under which they set, AB Lindec can in no way be held responsible. AB Lindec is only responsible for the quality of the products at the time of delivery.
